I know I’m reblogging this again but I have to add my own two sense on the matter. Most other auto manufacturers have had the stuck accelerator problem in the past due to floor mats and they have all learned a very important lesson: if BOTH accelerator and break are all the way down, apply the breaks and cut the throttle.
And even then they also have it so mashing the start/stop button or pressing and holding it kills the car
From that one report of the cyber truck crashing even when the brake was pressed, it seems like Tesla has not done their research and may not even have a contingency in the code for this. So it’s a hardware AND software problem
From what I understand, it’s not so much a design flaw as a production flaw; they made a change in manufacturing. They used a different chemical for something at some stage and that’s what caused the pedal cover to slip off.
This was a failure of process.
I assure you, every major manufacturer in the world is either in the process of examining their processes to make sure that this particular issue isn’t going to affect them, or has already done so. (I’m willing to bet that, in most cases, the investigation consisted of confirming that they don’t use the chemical in question, along with some kind of “…because we’re not idiots” notation in corporatese.)
What a lot of people don’t appreciate is that corporate bureaucracy exists for a reason. Bureaucracy is the corporate equivalent of legislation– every layer of it was born in red ink. As someone who has managed software deployments in production environment on systems used by millions of people each day, let me tell you, every step in that process is necessary. Oh, sure, it might seem like a lot of rigamarole for a minor change, but the problem is that people are notoriously bad at judging what a minor change is. I have personally been frustrated by a two-hour process (preceded by a week of paperwork, meetings, and approvals) to make a change in production that I knew full well would have no impact that, in actuality, took seven seconds and didn’t require the traffic routing, load testing, etc. And I was right, it went without a hitch. Then two days later I spent fourteen hours on a call where half the system was down and it turned out that someone made a very similar change, and didn’t say anything the entire time because he honestly didn’t see how what he did caused what happened. “It shouldn’t have affected anything!” If he’d followed process, there would have been no impact at all.
These tech bros think that they can revolutionize an industry by “streamlining the process” when they don’t understand that the existing processes are the streamline. Sure, if they’d taken a week to test the impact of the change in process, it would have cost them a week, but it’s gonna take more than a week to collect the information necessary to find out how much money this cost them. It’s not just the cost of the recall and repair, it’s the immediate impact this is going to have on sales, the long-term impact on consumer confidence in the brand, and, of course, a stock chart that looks like this:
ALT
That is a bad chart. And it’s not going to get better.
You know what, since I’m thinking about it anyways, let’s talk formalwear accessories. Most of these are traditionally menswear but a bit of gender fuckery is good for the soul, and frankly most of these are about making your mass-produced clothing fit and lay properly without having to go to the tailor.
Shirt stays: these go around your thighs to hold your shirt down, so that it stays smooth and tucked in. They’re usually elastic, with 1-3 clips, and if you wear skirts frequently this is a GREAT way to make sure your top doesn’t ride up. The clips will be visible if you’re wearing something tight, so loose pants or skirts are where these do best. There’s also an insane version that clips to your socks, but that is for lunatics. If you wanted, you could also use one of these clips to hold up thigh-highs.
These do a great job of smoothing and narrowing the waist area by keeping your shirt from bunching there.
Sleeve garters: usually metal, leather, elastic, or silk. These are usually worn with button-down shirts to adjust where your cuff falls on the wrist or hand. They’re properly worn on the upper arm, and you pull the fabric of the sleeve above the garter until you cuff is where you want it. Because this creates a puff of sleeve at the bicep, it also broadens the appearance of the shoulders. It’s great if you’re working with your hands or if your sleeves are often too long for your preference.
Waistband clip or belt adjustment clip/buttons
Three different ways of tightening the waistband of a pair of pants or a skirt. You’re not going to get more than an inch or so tighter without weird bunching, and for most of these you’d want them to be hidden under a shirt or jacket, but they do the job if that’s something you’re having issues with.
Collar pins: There are so many fun ones out there, both with and without chains. They’re not terribly practical, though the slight weight may help keep your collar where you want it. Also consider collar tips, which pin (surprise) to the very tips of your collar points.
Sweater clips/guards: meant to hold your sweater or cardigan mostly closed. Great if your cardigan doesn’t button, or if you don’t like it to be buttoned all the way.
There’s tons of other stuff out there like this–etsy is a great place to find this stuff. A lot of these are old solutions to the very modern problem of mass-maufactured clothes not being as one-size-fits-all as advertised, but they’re also a fun way to put a bit of personality into businesswear.
this is by far my favorite safety/warning sign btw. they really went off with this one
No cuz I fucking love this sign. It’s not an actual barrier so it’s not like some sort of challenge it simply says “fuck around and you will find out”
Ohohoho I LOVE “fuck around and find out” signs, especially the really dramatic and ominous (but true) ones
(Context for the last one: it’s a WWII era sign posted around the soldiers’ washroom mirror, warning them to never discuss military plans in places where civilians could hear them and report back to the enemy, e.g. in restaurants and pubs in the country. “Loose lips sink ships”.)
I also love these two, which I would place in the category of “You already fucked around, now you’re about to find out.”
Aerated water is fucking scary. It’s water that has a fuckton of gas in it, which reduces the buoyancy to the point where you will immediately start to sink if you fall in.
ive been collecting these recently and wanted to add some of my favorites
Skeletor has forever destroyed our ability to come up with voices for skeleton characters.
this is like saying NASA has forever destroyed our ability to wonder what it’s like on the moon. like we can still use our powers of imagination if we want to but the question’s pretty much fucking settled.
“Rent should be no more than 30% of household income” is a really funny and roundabout way to say “property owners as a class are entitled to 30% of gross wages”
ALT
ALT
ALT
ALT
ALT
ALT
ALT
ALT
